This is your Incoming Air Temperature Sensor



Here is a closer look.




Here are the tools you will need. 1 roll of electrical tape. 1 package of 4.7k Ohm resistors from Radio Shack.



The first step is to pull out the IAT sensor.



The second step is to bend your resistor to fit into the IAT sensor.



The third step is to place the resistor in the opening on the IAT sensor. (Mine looks a little sloppy :P)



Now tape the resistor in, tape it good so that it doesn't come out.



Now find a place you would like to put your IAT sensor back at. I taped mine to the back of my air intake. Your finished.